Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - soso2

Pages: 1 [2]
16
Cube 3D printer discussion / Re: FrankenCube v0.1 Its ALIVE!!!
« on: June 05, 2016, 08:23:12 am »
I've finally figured out the wiring and configuration for my frankencube. The unit is printing better than it ever has.  Its quieter, faster, more accurate and much more flexible.  Can't post any pics for the next few days because our internet at home took a lightning strike.  I'll post a copy of the customised marlin firmware as soon as my home internet comes back online along with some revised wiring details and further instructions.
Hi Dan
 I have my ramps, wired as shown in the pictures, but when I try to install the firmware, I get errors, I think maybe I wired something wrong, can you take a picture of the wiring again, or just let me know..  Thanks Dan, I'm glad you put this together for us..

17
Cube 3D printer discussion / Re: FrankenCube v0.1 Its ALIVE!!!
« on: June 02, 2016, 02:33:22 pm »
Yes there only  3 endstops, but in his picture of the ramps board, he has something plugged in the Z- min pins.. so when he says connect the endstops as shown, I got confused..  I just got the firmware installed on my ramps..  keeping my fingers crossed.

18
Cube 3D printer discussion / Re: FrankenCube v0.1 Its ALIVE!!!
« on: May 26, 2016, 03:39:53 pm »
Thanks for the write up,   
It looks like there's 4 endstops installed?  is this right? from the picture

Pages: 1 [2]