Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 6676 times)


  • Newbie
  • *
  • Posts: 18
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #75 on: June 19, 2016, 10:57:43 am »
Hmm it seems to me that your endstops aren't wired correctly. I put them to the tip pins shown in here:; xmin, ymin and zmax.
 Your right, I had my end stop x-min y-min z-min,  Will this stop my z axis from raising the print bed 100mph?  z axis is super fast, almost broke my bed. I took the bed off for now, until I get this right..
 I'm sorry to be asking you so many questions, I am also googling a lot of info as well.
Thank you again