Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 6712 times)

spegelius

  • Jr. Member
  • **
  • Posts: 51
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #45 on: February 27, 2016, 12:51:46 pm »
Printed a dampener with FilaFlex for Y-axis and it works better that expected: Y-axis is by far the most silent of all now. Now to design similar setup for X-axis, i need to do it bit differently due to the differences how the steppers are attached to the frame.

FilaFlex: hard to get printing right, but when succesfully printed, it's very tough material, flexible, but tough. To get it printing properly with Cube 2, spped must be kept low. I had success with max 10mm/s printing speed set in Kisslicer. Faster speed just made the filament bend before the nozzle opening and jam.

Also PETG works fine, bough REAL transparent red. Seem to be getting more warping than with PLA even though PETG should be better in that regards...

Some assorted 3DPrinting pictures: https://www.dropbox.com/sh/qyosfww7zud15l4/AAAp6i1h_ljRp9sGNML-bRyya?dl=0