Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rvalotta

Pages: 1 [2]
16
Cube 3D printer discussion / Re: Alternative slicer to the cubes standard software
« on: April 20, 2015, 06:43:35 pm »
Thanks for the info... Sadly I had to put the printer away. Damn thing kept turning itself off mid print... Waiting on new electronics and then taking it from there.

Going to start with just a brain transplant then decide what i want to do from there. seriosly considering a new extruder as well but thats going to take getting some $$$ to do that

Happy 3d Printing.

17
Cube 3D printer discussion / Re: Alternative slicer to the cubes standard software
« on: April 19, 2015, 07:03:44 am »
What exactly did you do on your Mac? and while i'm thinking about it were you able to find a cubex for osx?

18
Cube 3D printer discussion / Re: Identifying Cube Gen1 vs Gen2
« on: April 13, 2015, 06:38:54 pm »
and it is suppose to print in the caution engraving? (Yes I have a gen 1)

*Edited do to poor english and bad typing*

19
Cube 3D printer discussion / Identifying Cube Gen1 vs Gen2
« on: April 13, 2015, 02:07:33 pm »
Is there a easy way to tell what gen device I might have?


20
Cube 3D printer discussion / Re: Crap hack. Bulk filament
« on: April 13, 2015, 10:21:08 am »
Silly Question will this work with a chip from a cartridge that is near empty?


21
Cube 3D printer discussion / Re: Alternative slicer to the cubes standard software
« on: April 13, 2015, 07:42:55 am »
I was pretty much just given a Cube 3d printer and have a question. Seeing as you are able to adjust the temp at the gcode side, does this mean i really don't need to hunt out a pla cartridge to scavenge a chip from?

Rocco

Pages: 1 [2]