Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SpencerR87

Pages: [1]
1
Does it need to be at 50%? I have two at 10% currently with new ones coming.

2
Cube 3D printer discussion / Different Slicer software for cube3?
« on: December 14, 2016, 07:50:44 am »
Picked up a cube3 the other day brand new dirt cheap as a beginner printer. The software is super easy to use however you have no control. Some prints do ok and others..not so much. The test prints that cubify has sent me always come out perfect so they make me seem like I'm crazy lol.

Are there any other slicer options and a detailed hack for the filament?

Pages: [1]