Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - packNsnap

Pages: [1]
1
Cube 3D printer discussion / Re: Cube 2 Not heating - Fan not working
« on: October 07, 2015, 05:44:12 pm »
IT WORKS!!!!!!!! THANK YOU AND THIS THREAD =)

2
Cube 3D printer discussion / Re: Cube 2 Not heating - Fan not working
« on: October 07, 2015, 12:42:29 pm »
per your comment, i am going to go hoem and short these wires together.... lets see what happens.

3
Cube 3D printer discussion / Re: Cube 2 Not heating - Fan not working
« on: October 07, 2015, 09:41:23 am »
Dan,


This is what is happening with me!  I think i may be able to fix it then right?

Did you simply buy something like below and wire it in?

http://www.ebay.com/itm/77-Degree-Celcius-Thermal-Cut-Off-Fuse-Microtemp-4168A-NZJB-QTY-10-ea-K1-/151313596783


4
Cube 3D printer discussion / Re: FrankenCube v0.1 Its ALIVE!!!
« on: October 05, 2015, 04:42:07 pm »
so i was thinking of doing this since i got a used cube 2 about a month ago. But now i am getting the temp error and its not heating up. i assume its a faied head.


Now i think i have no choice. I really cant fork out 200 for a new head from 3d systems. Is replacing the head with one like the one shown (jhead ) possible without full modding it ?

I am fairly good with electronics, but completely new the 3d printers.   I NEED HELP =c

Pages: [1]