Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bkandor

Pages: [1]
1
Cube 3D printer discussion / Cube3 with kisslicer and bulk filament?
« on: January 17, 2015, 12:46:43 pm »
Hi,

I just recently picked up a cube3 printer.  So obviously I want more control over the printer than the extremely lite version cubify software that it ships with.   I seen the threads about kisslicer and cubeit for the cubex and cube2 but I've not been successful getting a file recognized by the cube3 yet.  Any tips would be appreciated.  I'll continue to experiment and if I come up with anything I'll let you know.

Thanks,

Pages: [1]