Cube 3D printer community

Thanks your reply I got it finally. I rewrite as full with the printer. I used that way is,started with  full cardridge(very little print), stop, changed cardridge, and machine write to totaly empty cardridge as full
now I just need better slicer

Cubify cube gen1 firmware v1.06

Hi all, I wondered something , I have cube 1st generation, firmware is 1.06. Does firmware 2.x.x mean that for cube 2nd generation ?
Can I use 2.0.8 for my cube ?
I have 2 cardridge, I had use them for trick 3d printer, but I did not take them off while printing, so when I try new print, cube says, " The cardridge is empty ". I have full cardridge so I'll try Dan's way, so I wonder, If I up/downgrade firmware to v1.00 can I use again them for start another print as a half load cardridge ? Or When start printing with full cardridge, and then take off it, is that printer write a new information to cardridge?
Sorry my English, I hope I could explain.
Thanks.


"" Jason says:
January 16, 2014 at 5:49 am
These are the hex files I’ve got for my gen1 cube: v0.24, v1.00, v1.06, v1.07 and v1.10.

https://drive.google.com/folderview?id=0By9lF8Q3EZlNeVdhZUZlV1kyS2M&usp=sharing

v1.10 doesn’t allow the cartridge swap trick. v1.07 does allow you to change cartridges, but doesn’t reset the amount of filament left in the ‘empty’ cartridge as outlined by Kevin and others. v1.00 does reset the filament amount, but has a bug that stops the ‘firmware update’ button working. If you use this one, you’ll have to do a factory reset to start the cube in firmware loader mode. (Hold the round function button on the front of the Cube and plug the machine back in while continuing to hold the button. Note: this will remove all your saved settings!)  ""