Cube 3D printer community
General Category => Cube 3D printer discussion => Topic started by: Ashley Watkins on January 25, 2015, 01:15:27 pm
-
Hi! New-ish CubePro Duo user here!
I've been having some difficulties with spotty printing (should be a flat surface...isn't.) and now I'm receiving a 'Filament Error' message.
I've determined the problem is the jet itself and not the filament (by running the same material through the other jet. Worked beautifully!)
Now. Any ideas how to go about diagnosing/fixing this?! I'm not even sure how to begin! :o
Thanks ;D
-
I would heat your nozzle and use a bit of piano wire to make sure it is cleared of any clogs.
-
Ashley, how'd you go with this issue? Was it a case of clogged hotend?