« previous next »
Pages: [1]

Author Topic: Repairing and Upgrading Cube Gen2  (Read 604 times)

ShadowedR

  • Newbie
  • *
  • Posts: 5
    • View Profile
Re: Repairing and Upgrading Cube Gen2
« on: April 28, 2016, 01:37:06 am »
The print job and setup at the moment.

Also, I'm running low on that expensive glue.
I've not had much success printing PLA on the bare plate, but I've seen Pritt Stick ( or w/e is avail in your country ) will work just fine?

Any other suggestions?
Logged
Pages: [1]
« previous next »