Cube 3D printer community
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
This topic
This board
Entire forum
News:
Create A Forum Installed
Home
Search
Gallery
Members
View the memberlist
Search For Members
Login
Register
General Category
»
Cube 3D printer discussion
»
Level Printpad Hell
»
Message #21
« previous
next »
Print
Pages: [
1
]
Author
Topic: Level Printpad Hell (Read 391 times)
Dan
Administrator
Jr. Member
Posts: 75
Re: Level Printpad Hell
«
on:
August 29, 2014, 05:22:10 am »
Its a pretty tedious task. The traditional way is to use a piece of paper and gradually adjust each screw so that all four corners allow the 80gsm paper to *just* slide under the printhead with *some* but not much resistance. Honestly its a pain in the rear end. I recommend using my way of doing it. After spending hours on the old way, the new way is extremely accurate and take much less time / effort. see here:
http://cube3d.createaforum.com/general-discussion/easiest-and-most-accurate-way-to-level-the-cube-3d-printer-printpad/
Welcome to the forum BTW.
Dan
Logged
Print
Pages: [
1
]
« previous
next »
General Category
»
Cube 3D printer discussion
»
Level Printpad Hell
»
Message #21