Author Topic: kisslicer infill settings  (Read 845 times)

HittinBottom

  • Newbie
  • *
  • Posts: 17
    • View Profile
Re: kisslicer infill settings
« on: February 10, 2015, 02:51:32 pm »
I'm not sure what you can change in kisslicer.  I'm still a novice on 3D printing and the slicers.  I do know that this one is a ton better than the cube software.  The only drawback is the printing time isn't updated like the cube software and you can't tell if you have enough filament left or not.  Hopefully before too long I can get this thing to print bulk.