Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 4887 times)

fritshgl

  • Newbie
  • *
  • Posts: 14
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« on: December 17, 2014, 02:55:40 pm »
Hello  Dan

I did build the minitronics Electronics in my cube. At the moment i am testing the x,y,z movements and the extruder. With regard to the thermistor of the extruder i have the impression that it is a 200k thermistor and not a 100k thermistor. Because with a 200k thermistor in the firmware the temperature at room temp is 22 Celcius, with a 100k thermistor only 6 C.  In your firmware you have the 100k thermistor. I think your 100k thermistor is the one of your new hotent. Is that right.
Beside that  the max temp i can reach with 12 volt is +/- 150 C. So i wil use a relais to supply the hotend with 24 volt (the original powersupply).

Kind Regards,

Frits