Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 9117 times)

fritshgl

  • Newbie
  • *
  • Posts: 14
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« on: November 26, 2014, 01:01:00 pm »
Hello Dan,
I am very happy with your information because i am thinking about doing the same with my cube 3d 2nd gen. printer.
 About a year ago i did build a 3d printer (http://www.thingiverse.com/make:72807) with minitronics Electronics (reprapworld.com).
So i am thinking of using mintronics because a have some experience  with that and not with adruino.
I would very much like more information about the marlin firmware and the wiring.
I assume you want to print with ABS because you mention that you need a higher temperature than 215 C?.
So thanks again and Kind Regards,
Frits (The Netherlands)