Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 6582 times)

spegelius

  • Jr. Member
  • **
  • Posts: 51
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #75 on: June 19, 2016, 04:27:57 am »
I just tried it, I don't understand, why my x, y, z, axis are only going in one direction, if I try the other direction, pronterface says endstop hit.. I also tried to raise my Z axis up 10mm and it went so fast all the way to the top, and kept trying to go..  You are saying you are getting good prints with these setting??
 I don't understand what im doing, wrong.. 

Hmm it seems to me that your endstops aren't wired correctly. I put them to the tip pins shown in here: http://www.reprap.org/mediawiki/images/0/06/RAMPS_dossier.pdf; xmin, ymin and zmax.