Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 9091 times)

soso2

  • Newbie
  • *
  • Posts: 18
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #75 on: June 18, 2016, 05:52:20 pm »
Did you pull the latest version of the configuration? I made a new commit that moves the origin to the corner, which should allow you to move it freely

No I didn't upload the latest verison, I thought the only change was the SD card support, I will upload and let you know, a little later.. Thanks for all your help.
I just tried it, I don't understand, why my x, y, z, axis are only going in one direction, if I try the other direction, pronterface says endstop hit.. I also tried to raise my Z axis up 10mm and it went so fast all the way to the top, and kept trying to go..  You are saying you are getting good prints with these setting??
 I don't understand what im doing, wrong..