Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 9102 times)

geoff.sim

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #45 on: October 06, 2015, 08:01:32 am »
Mine is all done now. Just need to tune it.
Here is a pic of the finished item.

I damaged the nozzle after reaming it out after a bad blockage, and so replaced it with a HEX extruder.
I also managed to get it to fit in the original location, and with minor modification, the extruder cover also fits.

The PSU is the original one. I am using all 24v, with the exception of the extruder fan (original) and arduino.
these are run off a 12V BUCK convertor).

Very quiet when not in use (and I don't mean off). The case fan is on when motors are running, and 2 mins after.
Extruder fan is on when temp is >35 degrees.

Oh, and it all Bluetooth or SD card printing. No USB in sight!

I have yet to complete the tuning of speed and velocities for good printing, but I am happy with the results.