Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 6979 times)

Joop

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #30 on: June 05, 2015, 03:23:24 pm »
Hallo Fred,

I didn't know i needed to use the jumpers under the stepper drivers, but now i put in and stepper motors working accurate.
I also was confused about the home values and endstop for the Z-as because for the Cube this is working from top to bottom, but now correct this in the firmware and with Prontoface i can control all motors also the extruder and heater element is no problem till 230C with the 12V.

After calibration i start printing my first object and the first layer is going ok, but when the second layer starts the nozzle is little to high from the first layer.
So probable i need to fill in other parameters for generating a code gcode aswell.
Do you know the Nozzle Diameter of the Cube? 0.25? And the value of the 1st Layer height and other layers? Also 0.25?
What is the best speed and temperature for ABS to print. My first layer print slower as the second, is that ok?

Thanks in advance

Joop