Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 6979 times)

Joop

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« Reply #30 on: June 03, 2015, 03:55:53 am »
Hello Frits,

Thank you for your reply. I hope i can test this evening.

I read in your source code "#define DEFAULT_AXIS_STEPS_PER_UNIT   {160,160,160,350}  // hangt van stapgrootte stepperdriver af" and your comments says that the value depends about the stepperdriver. I'm using the "Stepper Drivers A4988" with the original Cube Stepper motors, but u are using other Stepper Drivers? Can i use the same values? Or does Dan using the same Stepper Drivers as me and i need to use his values from his firmware?

What is the best software to calibrate or test my system?

Thank you in advance.

Joop