Author Topic: FrankenCube v0.1 Its ALIVE!!!  (Read 4773 times)

fritshgl

  • Newbie
  • *
  • Posts: 14
    • View Profile
Re: FrankenCube v0.1 Its ALIVE!!!
« on: December 22, 2014, 06:16:17 am »
Hello Dan,

Switching 24 volt to the extruder with a relay was not a good idea. A lot of noise from de relay.
So I followed your suggestion end discovered that the minitronics can also run with up to 24 volt.
Now I am running the electronics with 19 volt, and a separate 12 volt supply for the cooling fans.
The heating up of the extruder is now really fast. So a very good suggestion from you. Thanks again.

Frits