Cube 3D printer discussion > Cube 3D printer discussion

First layer blob

(1/4) > >>

ssstraub:
Does everyone's second gen cube make a big blob after completing the first layer? Mine seems to do this no matter what file I load.

Can anything be done? Is it the fault of the Cube firmware or the Cube slicer?

itsnewby:
While the extruder is heating, it may ooze, so clean that off before the print starts.

ssstraub:
The fine preheating string is not what I'm referring to in this case. I'm referring to the extruder coming to a complete stop after the first layer is 100% finished for about 3-5 seconds, and making a blob of PLA in that spot. After that it continues normally until it's finished and never stops again.

Happens on every single one of my prints.

Vicm:
Try to re-calibrate printer, first calibrate the plate about 3-4 inches below extruder, then re-calibrate it as usual with a a sticky note.

ssstraub:
I will try recalibrating, but I don't think that's related.

No one else's 2nd gen Cube has this issue?  ???

Navigation

[0] Message Index

[#] Next page