Author Topic: Filament Error?  (Read 2294 times)

Ashley Watkins

  • Newbie
  • *
  • Posts: 1
    • View Profile
Filament Error?
« on: January 25, 2015, 01:15:27 pm »
Hi! New-ish CubePro Duo user here!

I've been having some difficulties with spotty printing (should be a flat surface...isn't.) and now I'm receiving a 'Filament Error' message.
I've determined the problem is the jet itself and not the filament (by running the same material through the other jet. Worked beautifully!)

Now. Any ideas how to go about diagnosing/fixing this?! I'm not even sure how to begin!   :o

Thanks  ;D

Share on Facebook Share on Twitter


Swinson Terry

  • Newbie
  • *
  • Posts: 1
    • View Profile
Re: Filament Error?
« Reply #1 on: January 30, 2015, 11:41:59 am »
I would heat your nozzle and use a bit of piano wire to make sure it is cleared of any clogs.

Dan

  • Administrator
  • Jr. Member
  • *****
  • Posts: 75
    • View Profile
Re: Filament Error?
« Reply #2 on: February 28, 2015, 05:39:09 am »
Ashley, how'd you go with this issue?  Was it a case of clogged hotend?