Author Topic: Crap hack. Bulk filament  (Read 60413 times)

spegelius

  • Jr. Member
  • **
  • Posts: 51
    • View Profile
Re: Crap hack. Bulk filament
« Reply #105 on: April 11, 2016, 03:57:13 am »
Sigh... started printing Hunters_scull yesterday, using Bamboofill filament. It went fine for ~7 hours and quality seemed to be very good, but something happened during night and filament jam. Hopefully i can find a good reason why, otherwise it's just hit and miss what to do about it... It could be the hot end itself, need to see if there's some rough edges in the input hole. Or it could be a tight spot in the bowden tube setup, need to check those and use 2mm drill bit to widen the tube ends. Also Bamboofill might be just too fragile and constant forward/backwards movement might weaken it and gear grinds a hole in it, causing a stall.