Author Topic: Alternative slicer to the cubes standard software  (Read 15091 times)

Camstar

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: Alternative slicer to the cubes standard software
« Reply #15 on: January 18, 2015, 10:15:37 am »
Well, you are completely right, and I found out this afternoon. Just have to get into Kisslicer. I also adjusted the thicknes off my PLA. The first run with CubeitMod enabled, the flow was too low, and I am now in the middle of a retry. I have included a picture off the initial layer with infill of my testprint (without the cubeitmod).

I normally use a little water to reuse the existing cubestick layer and smooth it using a disposable knive blade. It's not perfect, but I don't see the problem you are having (I think ;-)